Start Here
The shortest sensible path from unboxed printer to reliable weekly workflow.
Most resin printing knowledge is scattered across forums, YouTube channels, and manufacturer manuals, each written by someone at a different point in the learning curve. This page puts it in order. Four stages, each with the articles and course lessons that matter most for that stage. Work through it top to bottom, or jump to the stage that matches where you are now.
- 01
Before you print
Choose the right gear without wasting money on the wrong one.
Most beginners buy too early, based on the wrong spec, and spend the first three months fighting a machine that was never right for them. Start here: what to buy, why, and how to decide between the obvious options.
- Free course: Section 1 → Six lessons from gear decisions to workspace setup
- Topic hub: Buying and Choosing →
- Resin printer buying guide →
- 02
First prints
Calibrate once, properly. Everything after that is easier.
A single careful calibration session saves you weeks of chasing exposure problems and blaming the resin. The articles in this sequence cover the build plate, the first test print, and what to read off each result.
- Free course: Section 2 (first four lessons) → CRISP workflow from calibration to a clean miniature
- Topic hub: Calibration and First Prints →
- 03
When prints fail
Identify the failure mode. Fix the cause, not the symptom.
Every resin printer produces bad prints eventually. The goal is to recognise the pattern quickly, diagnose the root cause, and fix it without a week of random adjustments. This sequence covers the common failure modes and what each one actually means.
- Topic hub: Failures and Recovery →
- Print fail diagnostic tool → Answer a few questions, get the most likely cause
- 04
Building a workflow
A repeatable process is the difference between printing and just occasionally getting lucky.
Once the calibration is done and the failure modes are understood, the work becomes habit. This sequence covers the CRISP framework, wash and cure, and how to build a session routine that produces consistent results without thinking hard about it.
- Topic hub: Workflow and Post-Process →
- Resin cost calculator → Understand the real cost of your workflow
Free video course
The fastest way through steps 1 and 2 is the free course.
Twenty lessons, structured in the same order as this page. Watch the videos or read the companion articles. Free with a newsletter signup, no upsells.