Free Diagnostic
What went wrong with your resin print?
Pick the failure pattern that matches what you found on the build plate. Two or three short questions later, you have the most likely cause and a link to the fix.
Runs in your browser. No signup. The diagnosis pulls from the same troubleshooting framework taught in the course.
How this diagnostic works
Resin print failures look chaotic when you have not seen them before, but they fall into a small number of patterns. The same questions a calm troubleshooter asks (what does it look like, what changed since the last good print, is the FEP still intact) get to the most likely cause faster than throwing settings at the wall.
The branches in this tool are pulled from the troubleshooting article and the cleaning-up-after-a-failure guide, both written from years of failed prints. The fix links go to the relevant article rather than restating the procedure here, because the procedures are long and benefit from full context.
If the diagnosis below does not match what you are seeing, the full diagnose article carries every failure pattern and the order to check them in.