Articles tagged Resin | Micron Monster

Black nitrile gloved hand holding a small grey resin print under running tap water in a kitchen sink

21 April 2026

Can You Really Wash Resin Prints in Water?

Water washable resin used to be a beginner trap. In 2026 the better ABS-Like water washables make it the easiest place for a new resin printer to start.

White gloved hand holding a grey resin winged creature print that has fused and collapsed, rounded body with deformed wing ribs, blobs of over-cured resin, severe fusion defects from overexposure or support failure

26 March 2026

How to Diagnose Failed Resin Prints

A systematic approach to figuring out what went wrong after a resin print fails, with common failure patterns matched to their most likely causes.

Close-up overhead of a resin printer FEP film showing heavy diagonal gouges, multiple small cloudy puncture holes, and milky white patches across the transparent membrane surface

19 March 2026

How to Change the FEP on a Resin Printer

How to replace the FEP film on a resin printer vat, why the tension theories online are not worth your time, and what to check after replacement.

Open Elegoo printer from the front with build plate raised showing a large dark grey complex resin print still attached at the top, while a grey rectangular tile sits flat on the vat bed below, a partial detachment failure

13 March 2026

Cleaning Up After a Failed Resin Print

How to use Tank Clean after a minor failure, when to empty the vat, and how to handle the serious cases: a vat in midair, a FEP tear, resin on the screen.

Elegoo Saturn printer hood removed showing build plate raised with a large dark grey complex resin print hanging from it, heavily detailed armoured figure or bust still attached to plate above the vat, Wargamer resin bottles visible to the right

12 March 2026

Printing Bigger and Hollow Resin Miniatures

Settings adjustments for larger models, the drainage hole rule for hollow prints, and why water washable resin and hollow models do not mix.

Two identical grey resin Cones of Calibration v1 side by side on a light wooden surface, each a rectangular block with triangular spike teeth and embossed MICRON MONSTER and FAILURE text on top, printed at 35 microns on an Elegoo Mars 3 Pro

27 February 2026

How to Use Resin Printer Calibration Tools

Why borrowing exposure settings from forums does not work, what actually needs calibrating, and which calibration tool to start with for minis.

Saturn 4 Ultra build plate fully raised showing a large Lich King throne group print hanging upside down, three heavily armoured figures flanking a central ornate throne, dense lattice supports across the top, wet resin visible, purple ambient glow

19 February 2026

The CRISP Method for Resin Printing

CRISP stands for Consistent, Razor sharp, Improving, Safe, Painless. What each letter means in practice and why the order matters for reliable results.

Freshly printed build plate of dark grey fantasy miniatures still on lattice supports, wash and cure station blurred behind

10 February 2026

Resin 3D Printing for Miniatures

Everything a miniature hobbyist needs to start resin printing well: the right gear, safe setup, and the mistakes that waste most people's first month.